Lighting dimmer SCO-814 230V F&F
- Lighting dimmer SCO-814 230V F&F
Lighting dimmer SCO-814 230V F&F
Product description
1000W. For 35mm rail.
Lighting dimmer is used to switch on and off incandescent and halogen lighting with the possibility of adjusting the intensity of this lighting with any momentary (bell) switch.
Lighting dimmer is used to switch on and off incandescent and halogen lighting with the possibility of adjusting the intensity of this lighting with any momentary (bell) switch.
Operation
Lighting is switched on after a current impulse caused by pressing the momentary (bell) switch connected to the relay. Turning off the lighting will occur after the next impulse. Holding the button >1sec allows setting the desired illumination intensity (smooth illumination pulsation in the loop LOWER→ DARKER→ LOWER).
After each switch-on, the lighting returns to the previously set brightness.
Lighting can be controlled by multiple buttons connected in parallel located at different points in the room.
NOTE:
SCO-814 can work with illuminated buttons.
Technical data:
| Supply voltage | 230 V AC |
| Maximum load current AC-1 | 4,5 A |
| Executive element | triac |
| Status memory | YES |
| Status memory after power failure | NO |
| Maximum power of connected lamps | 1000 W |
| Installation | 3-wire |
| Application | incandescent lighting, halogen lighting, toroidal transformers |
| Load control | switching off at 0 (for inductive and resistive loads) |
| Connection | screw terminals 4.0 mm² |
| Tightening torque | 0.4 Nm |
| Power consumption | 0,3 W |
| Operating temperature | -25 ÷ 50 °C |
| Dimensions | 3 modules (52,5 mm) |
| Mounting | on a 35 mm rail |
| Protection degree | IP20 |
SCO-814 F&F
Ask a question
2 years
2 years
Write your opinion