Radio control relay bistable RS-407 B F&F

Operation
An impulse caused by pressing a button on the remote control sends a coded signal to the receiver. The remote control has protection against transmission interruption when the button is released. Thanks to this, even the shortest activation of the function results in transmission of a full data frame. Data transmission from the remote control is indicated by flashing red LED on the remote control. When the signal is recognized, the receiver will change the contact position to the opposite.

The RS-407B receiver works with dedicated devices manufactured by F&F: RS-P (remote control) and RS-N (flush-mounted transmitters). Up to 32 transmitters can be stored in the receiver's memory.
The operating range of the system is up to 100m (the operating range depends on many factors, including: atmospheric conditions (humidity), terrain characteristics (reflections), the height of the receiver and transmitter placement, and all kinds of obstacles, such as walls).

NOTE!
Before final installation of the receiver, make tests.
The receiver is equipped with a PROG button to associate a particular remote control/button with the receiver and to delete the receiver's memory.

Programming
Pressing and holding the PROG button >5sec will enter the programming state. After entering the learning mode, the receiver waits for incoming transmissions from the remote control (pressing the selected remote control button). Program verification takes place. If the button of a particular remote control has not been programmed before, the identification data will be recorded. Multiple remote controls can be assigned during one open programming session of the receiver. Briefly pressing the button <1sec. exits the programming state.
Pressing and holding the PROG button >8sec. erases the memory. After the deletion operation from the non-volatile memory, all remote control data are deleted, and then the memory is formatted for reprogramming.

Receiver signaling
LED red
blinking randomly: receiving mode
flashing fast: memory deletion
long blink: memorize function (remote controller)
short blink: function (remote control) already defined
3 blinks: memory full
long blink: formatting memory after switching on
red short blink: memory test after switching on

LED green
flashing every 1 s: learning mode
long blink: output activation