RS-407 M F&F radio control relay

Receiver RS-407M cooperates with dedicated devices manufactured by F&F: transmitters RS-P (remote control) and RS-N (flush-mounted transmitter). Up to 32 remote controls can be stored in the receiver's memory.

Operation
An impulse caused by pressing a button on the remote control sends a coded signal to the receiver. The remote control has protection against transmission interruption when the button is released. Thanks to this, even the shortest activation of the function results in transmission of a full data frame. Data transmission from the remote control is indicated by flashing red LED on the remote control. When the signal is recognized, the receiver closes the X1-X2 contact for 1÷2s (pulse).

The operating range of the system is up to 100m (the operating range depends on many factors, including: atmospheric conditions (humidity), terrain characteristics (reflections), the height of the receiver and transmitter placement, and all kinds of obstacles, such as walls).
NOTE: Before final installation of the receiver, make tests.
The receiver is equipped with a PROG button to associate a particular remote control/button with the receiver and to delete the receiver's memory.

Programming
Press and hold the PROG button for >5s to enter programming mode. After entering the learning mode, the receiver waits for incoming transmissions from the remote control (pressing the selected remote control button). Program verification takes place. If the keyfob button has not been previously programmed, the identification data will be recorded. Multiple remote controls can be assigned during one open programming session of the receiver. A short press of the button <1s exits the programming state. Press and hold the PROG button >8s to erase the memory. After the deletion operation, all remote control data are deleted from the non-volatile memory, and then the memory is formatted for reprogramming.

Receiver signaling
LED red
flashing randomly: data reception mode
flashing fast: memory deletion
long blink: memorizing function (remote control)
short blink: function (remote control) already defined
3 blinks: memory full
long blink: formatting memory after switching on
red short blink memory test after switching on

LED green:
flashing every 1s: learning mode
long blink: output activation