Lighting dimmer SCO-801 230V F&F
- Lighting dimmer SCO-801 230V F&F
Lighting dimmer SCO-801 230V F&F
Product description
Lighting dimmer is used to switch on and off incandescent and halogen lighting with the possibility of adjusting the intensity of this lighting with any momentary (bell) switch.
Operation
Lighting is switched on after a current impulse caused by pressing a momentary (bell) switch, connected to the dimmer. Turning off the lighting will occur after the next pulse. Lighting can be controlled by multiple buttons connected in parallel located at different points in the room. Holding the button for more than 1 s allows you to set the desired lighting intensity in one direction from the current setting to the maximum or minimum. The direction of change (brightening or dimming) is forced by the dimmer and always changes to the opposite after each setting. The dimmer has a memory of settings. After each switching on, the lighting returns to full brightness.
The dimmer has thermal protection. If the system overheats, the dimmer signals this by blinking the controlled lamp 3 times, and then turns off. After the temperature drops below the critical temperature, the dimmer can be switched on again.
NOTE:
SCO-801 can work with backlit buttons.
Technical data:
| Supply voltage | 230 V AC |
| Maximum load current AC-1 | 1,3 A |
| Executive element | triac |
| Status memory | NO |
| Status memory after power failure | NO |
| Maximum power of connected lamps | 300 W |
| Installation | 2-wire |
| Application | incandescent lighting, halogen lighting, toroidal transformers |
| Load control | switching at 0 (for resistive and capacitive loads) |
| Connection | screw terminals 2.5 mm² |
| Tightening torque | 0.4 Nm |
| Power consumption | 0,1 W |
| Operating temperature | -25 ÷ 50 °C |
| Dimensions | Ø54 (48×43 mm), height: 20 mm |
| Mounting | in a Ø60 flush box |
| Protection degree | IP20 |