Power limiter load control 200-2000VA 16A 2 modules 230V OM-632 F&F
- Power limiter load control 200-2000VA 16A 2 modules 230V OM-632 F&F
OM-632 F&F power limiter
OM-632 F&F
Power limiter is used to automatically disconnect the power supply of an electrical installation circuit when the set value of the power consumed by the consumers in this circuit is exceeded.
Attention!
Limiter adapted to protect circuits with so-called current converters, such as compact fluorescent lamps, electronic transformers, LED lamps.
Operation
The power limiter allows the circuit to be powered when the total power of the receivers in the controlled circuit is lower than that set on the limiter scale. Exceeding the set threshold of power consumption in the controlled circuit causes disconnection of power supply to this circuit. The power supply will be resumed automatically after the set time. If the value of consumed power is still higher than the set time, the circuit power supply will be disconnected again. The limiter has a delay circuit (1÷2 s), which prevents the power supply from being switched off in case of momentary exceeding of the set power.
| Power supply voltage | 230 V AC |
| Maximum load current AC-1 | 16 A |
| Maximum load current AC-3 | 4 A |
| Executive element | relay |
| Contact configuration | 1 × NO |
| Contact separation | NO |
| Tripping delay | 1÷2 s |
| Power limitation | 200÷2000 VA |
| Power return time | 10÷100 s |
| Supply return hysteresis | 2% |
| Connection | screw terminals 4.0 mm? |
| Tightening torque | 0.5 Nm |
| Power consumption | 0,8 W |
| Operating temperature | -25 ÷ 50 °C |
| Dimensions | 2 modules (35 mm) |
| Mounting | on a 35 mm rail |
| Protection class | IP20 |
F&F OM-632